Email sent to WMTA:
Aloha West Maui Taxpayers Association Staff, The State of Hawaii Department of Transportation, Highways Division (HDOT) is planning improvements to Honoapiilani Highway (State Route 30) between Launiupoko and Ukumehame that would address the roadway’s vulnerability to coastal hazards and sea level rise. HDOT anticipates preparing an Environmental Impact Statement (EIS) in compliance with the National Environmental Planning Act (NEPA) and Chapter 343 of the Hawaii Revised Statutes (HRS 343), Hawaii’s environmental impact statement law, to evaluate and disclose the project’s potential environmental impacts and identify permitting requirements. Prior to preparing a HRS 343 EIS preparation notice (EISPN) or NEPA Notice of Intent (NOI), which formally note the start of the environmental review process, we are gathering information from stakeholders and agencies who may have knowledge of the project area. At this time, we are seeking input on the proposed project as well as information related to any environmental, social, or economic concerns related to the project or project area, which are described in greater detail below. A location map showing the general project area is attached. Both State and federal funds will be used for this project, including a $22 million Rebuilding American Infrastructure with Sustainability and Equity (RAISE) construction grant. This grant was competitively awarded by the US Department of Transportation for projects that will have a significant local or regional impact. Overview of Proposed Project HDOT is proposing improvements to a 6mile stretch of Honoapiilani Highway between Ukumehame, at approximately milepost 11, and Launiupoko, at approximately milepost 17. Honoapiilani Highway, which is part of Maui’s Belt Road system, is a two-lane principal arterial highway that provides sole access to communities along the west coast of Maui with the rest of the Island. The Highway currently runs along the coastline and is chronically threatened by erosion, high wave flooding, and sea-level rise, as well as other less frequent but potentially devastating natural hazards such as tsunami and hurricanes/storm surge. The project will look at alternatives to address the susceptibility of the highway to these occurrences. Request for Input HDOT welcomes any comments and input you may have on the purpose and need for this project, possible alternatives, or any information related to any environmental, social, or economic concerns related to the project or project area. We kindly request that information or responses be provided in writing via email to me at: [email protected] by March 8, 2022. Upcoming Townhall Meeting Community town hall meetings will be held on-line as follows: Tuesday, February 22, 2022 6:00 p.m. to 8:00 p.m. Online Zoom Meeting: https://us02web.zoom.us/j/84932844163 or Join by Phone: 888-475-4499 (Toll-free) Meeting ID: 849 3284 4163 Thursday, February 24, 2022 12:00 p.m. to 2:00 p.m. Online Zoom Meeting: https://us02web.zoom.us/j/82088238611 or Join by Phone: 888-475-4499 (Toll-free) Meeting ID: 820 8823 8611 Meeting details are also on our project website – www.honoapiilanihwyimprovements.com. Please check back regularly as the website will be updated as the project progresses Please contact me with any questions and thank you in advance for your input. Sincerely, Genevieve Sullivan Project Manager To request language interpretation an auxiliary aid or special services (e.g. sign language interpreter, materials in alternate format), please contact me prior to the meeting dates. Please submit requests in a timely manner to allow an adequate period to fulfill requests. Genevieve Hilliard Sullivan Planner VI, HDOT Highways 808-587-1834 | [email protected] http://hidot.hawaii.gov/highways/ 869 Punchbowl Street Room 301, Honolulu, HI, 96813
0 Comments
WMTA SAFETY DIRECTOR DENNIS TERPIN ANNOUNCES OPPORTUNITY FOR CEU APPROVED SEMINARS February 15, 2022 – Honolulu, Live and Zoom
Defining the Role of the Chemical Hygiene Officer March 16, 2022 – Honolulu, Live and Zoom Advanced Laboratory Safety Please Register at – https://lawsonassociatesinc.thundertix.com/ WMTA BOARD MEMBER AND HEALTH AND SAFETY COMMITTEE CHAIRMAN DENNIS TERPIN ANNOUNCES TRAINING OPPORTUNITY!
Train - The - Trainer - Qualitative Fit Test (QLFT) Based on the New - ASTM - F3537-21 Standard Guide for Respirator Fit Testing Methods This class can be instructed, In Person, In House or Virtual ***DATE TO BE DETERMINED*** For information on these classes, please contact Dennis Terpin at [email protected] – OSHA - Standard Interpretations Respiratory Protection Against COVID-19 The Respiratory Protection Standard also does not require the employer to train its entire workforce in the proper use of the alternative respirator. However, the employer must ensure each employee it permits to use the alternative respirator, whether required or voluntary, is included in the Respiratory Protection Program and is following its applicable components, such as training in the proper use of that respirator, including putting on and removing it, any limitations on its use, medical evaluation, and its maintenance. Finally, regardless of the type of respirator(s) provided, employers must comply with all other applicable provisions of 29 CFR 1910.134. Fit test trainer requirements, according to OSHA’s Fit Testing Procedures—1910.134 App A Mandatory: Quantitative Fit Test (QNFT) 1. Calibrate equipment - (CNC), (CNP) 2. Perform daily and fit tests properly. 3. Perform a valid and recognize an invalid test. 4. Calculate fit factors properly. 5. Ensure equipment is in working order. Qualitative Fit Test (QLFT) 1. Prepare test solutions. 2. Set up equipment. 3. Perform tests properly. 4. Recognize an invalid test. 5. Ensure equipment is in working order. This fit-testing course reviews all Respirator Program elements required for all industries in the OSHA Respiratory Protection Standard (29 CFR 1910.134), clarifies when fit-testing is needed and when Quantitative Fit Test (QNFT) and Qualitative Fit Test (QLFT) are necessary, AIHA/ANSI Z88.10-2010 "Respirator Fit Testing Methods" and ASTM - F3537-21 Standard Guide for Respirator Fit Testing Methods. Session 1., Respiratory Protection Programs Development and Administration Objectives, Identify administrative components required for your employers and how to establish your respiratory protection program in accordance with 29 CFR 1910.134(c)., Apply applicable 29 CFR 1910.134 standards for your workplace activities, General Industry, Healthcare and Construction.,Identify the requirements for respirator and personal protective equipment interreaction in accordance with 29 CFR 1910.132..Describe the multiple technologies to conduct qualitative and quantitative fit testing in accordance with 29 CFR 1910.134.,Identify how the Respiratory Protection Standard interacts with other OSHA standards. Session 2., Developing Your Annual Employee Respiratory Protection and Training Program Requirements Objective, Applying the above concepts to your specific site and employee training program. Included is a generic PowerPoint training program and instructions on how to customize it for you company. Session 3., Fit Testing Workshop, Trainer the Trainer, Qualitative Fit Test (QLFT) Your instructor: Dennis A. Terpin Ph.D. O.H.S.T, EMT-P, retired Senior Industrial Hygienist, Hospital Safety Officer, and Emergency Manager at the University of Illinois Chicago. Dennis is a member of the ASTM F23.65 International Committee on Respiratory Protection, Personal Protective Clothing and Equipment. Dennis is a Master Level Instructor for FEMA/DHS specialization in respiratory protection at the Center for Domestic Preparedness. In his career he has set up 100s of respiratory protection programs and fit tested over 70,000 employees. For information on these classes, please contact Dennis Terpin at [email protected] Trainer - The – Trainer - Quantitative Fit Test (QNFT) also available |
If you wish to further discuss blog posts, please contat our office directly or contact us via Contact page.
Categories
All
|